Rockwell Automation 2755 2D Hand-Held Scanner - Manual (Page 33)

Connecting the Scanner 2–9
Publication 2755-6.4
To Host
Keyboard Connector
Power Supply
(May not be required,
see previous page.)
Scanner Cable
Wedge Synapse Cable
(2755-HFC-SP1-01 shown)
Scanner
To Keyboard
Note: Connect the
power supply last.
To connect the scanner cable to the keyboard wedge cable, push the
cable into the connector until you hear the connector snap in place.
To remove the scanner cable, press down on the small raised bump
on the connector end and remove cable.
!
ATTENTION: Do not install the wedge cable or
disconnect/connect the keyboard with power applied to
either the wedge cable or host device. Failure to
follow this caution may result in damage to the
scanner, wedge interface cable, or host device.
The Wedge Synapse cable connects between the keyboard and the
host device. Unplug the keyboard and connect one end of the wedge
cable to the host keyboard input. Connect the other end of the wedge
interface cable to the keyboard.