Rockwell Automation 2755 2D Hand-Held Scanner - Manual (Page 76)

Communication Setup (Synapse Cable) 5–15
Publication 2755-6.4
Intercharacter Delay
Some devices require a delay between characters to simulate the
effect of keystroke delays (characters are sent at a lower rate). The
default is short delay (5 msec). The options are:
•
Short 5 msec delay (default)
•
Medium 50 msec delay
•
Long 99 msec delay
Advanced Features
The advanced feature options allow you to store communication
parameters for up to two applications. If you have already
configured the scanner, all of the communication settings are stored
as Parameter 1 settings (default setting). Using the advanced feature
options, you can also create Parameter 2 settings. When using the
scanner, scan the correct parameter setting bar code to configure the
scanner for each application.
To set Parameter Set 1 configuration:
Configure the scanner communications as described in this chapter.
Since Parameter Set 1 is the default you do not have to scan the
Parameter Set 1 bar code.
To change the Parameter Set 1 configuration after storing settings in
Parameter Set 2, scan the Parameter Set 1 code and then change the
communication parameters as necessary.
To set Parameter Set 2 configuration:
1. Scan the Parameter Set 2 bar code.
2. Configure the scanner communication parameters as described in
this chapter.
To set defaults for a parameter set, scan the appropriate default bar
code. The selections are:
•
Set Defaults Current Parameter Set
•
Set Defaults Both Parameter Sets