Rockwell Automation 2755 2D Hand-Held Scanner - Manual (Page 49)

4–2 Configuring the Scanner
Publication 2755-6.4
Configuring the Scanner
1. Connect the appropriate Synapse cable to the scanner.
2. Apply power to the Synapse cable (if required).
3. Scan the Set Defaults bar code (in the Programming Guide for
2-D Bar Code Scanners) to configure the scanner with default
settings. Table 4.A lists the scanner default settings.
4. Scan individual bar codes (in the Programming Guide for 2-D
Bar Code Scanners) for parameters you want to change.
5. Scan the communication bar codes for the Synapse cable.
Scanner Default Settings
Table 4.A
Scanner Default Settings
Configuration Parameters Default Setting
Programming
Guide Reference
Set Default Set Defaults 1-1
Symbologies
All Enabled,
except
I 2 of 5, and
Codabar
1-3
Code 39 Options
Code 39 Full ASCII Enabled 1-6
Code 39 Check Digit Disabled 1-6
UPC/EAN Options
Transmit UPC-A Check Digit Enabled 1-7
Transmit UPC-E Check Digit Enabled 1-7
Convert UPC-E to UPC-A Disabled 1-7
Decode UPC / EAN Supplemental Disabled 1-8
Convert EAN-8 to EAN-13 Disabled 1-8
UPC-A Preamble
System
Character
1-9
UPC-E Preamble
System
Character
1-9