Rockwell Automation CS3000 V6.1 MMI FlexPak, GV 3000, Liqui-Flo - Manual (Page 12)

1-2 Control and Configuration Software V6.1
1.3 Hardware Requirements
Before installing and using the CS3000 software make sure you have the following
hardware:
•
An IBM or IBM-compatible 486 or Pentium personal computer running Windows
3.1, Windows 98, or Windows NT.
•
16 Mbytes of RAM (minimum)
•
A hard drive with at least 1 Mbytes free space available for the CS3000 software
•
A 3.5" floppy drive
•
A Monochrome or color monitor: VGA or better
•
An RS-232 serial COM port for communicating with the drive
•
An RS-232 serial cable with:
•
A 25-pin or 9-pin D-shell connector for your personal computer
•
A 9-pin or 25-pin male D-shell connector for the drive.
The GV3000 drive is equipped with a terminal strip as well as a 9-pin D-shell
connector. Either one can be used to connect to the personal computer. Refer to
section 2.3.1 for additional information.
1.4 Cables
The Interface cable can be used to connect the personal computer to the drive.
The Adapter is required, if your personal computer has a 25-pin COM port and you
want to use one of the specified Interface cables.
Table 1.1 - Cables
Drive Drive
Connector PC
Connector Interface Cable Adapter Cable
Part No.
FlexPak3000 25-pin 9-pin
25-pin 25-pin to 9-pin
25-pin to 9-pin
772.27.00
772.27.20
GV3000 9-pin 9-pin
Liqui-Flo 25-pin
9-pin to 9-pin
25-pin to 9-pin
772.27.10
772.27.20