Rockwell Automation CS3000 V6.1 MMI FlexPak, GV 3000, Liqui-Flo - Manual (Page 33)

Configuring the Drive 3-9
Important: If you change a drive’s control type parameter (for example, vector or
volts/hertz for GV3000 drives), a message is displayed notifying you that
changing the control type will reset parameters to their default values and
prompting you to continue. If you select Yes to continue, the parameter list
is changed to show only parameters that are relevant for the new control
type, and parameters in the Editor are set to defaults. These changes only
affect the configuration in the Editor.
Selecting OK in the Parameter Assignment dialog box sets the selected parameter
value and exits the dialog box. Cancel ignores any changes and exits the dialog box.
3.5.2 Ending an Editing Session
When you have finished editing parameters, select OK from the Configuration Editor
to write the values of the edited parameters into the opened configuration. You should
then use the Save command from the File menu to save the edited configuration file to
disk.
If you select Cancel from the Configuration Editor, a message is displayed prompting
you to ignore the changes or accept them. If you ignore the changes, any new
parameter values entered during the editing session are ignored, and the session
ends.
3.5.3 Entering and Editing a Configuration Description
You can add a description to a configuration file that documents information you want
to convey about the configuration. The configuration description appears in the main
window under the name of the opened configuration and on printouts of the
configuration.
To enter or edit a configuration description:
Step 1. From the Config menu, choose Description.
The Configuration Description dialog box appears as shown in figure 3.5.
Step 2. Type in new text or edit and existing description. See table 3.1 for editing tips.
Step 3. Save your edits and close the dialog box by clicking OK
Figure 3.5 – Configuration Description Dialog Box