Rockwell Automation CS3000 V6.1 MMI FlexPak, GV 3000, Liqui-Flo - Manual (Page 43)

Tuning GV3000 and Liqui-Flo Vector Drives 5-1
C
HAPTER
5
Tuning GV3000 and Liqui-Flo
Vector Drives
Important: The drive tuning functions are available only for GV3000 and Liqui-Flo
drives using vector regulation. If you have a GV3000 or Liqui-Flo drive
using volts/hertz regulation, or a FlexPak 3000 drive, you cannot use
these functions.
The drive tuning functions aid in the setup of drive tuning parameters. You should set
up the drive (except the drive tuning parameters) before performing drive tuning. You
should also save your drive configuration before tuning the drive. The drive must be
connected to the motor to perform some of these functions and the motor nameplate
information must be entered correctly.
These functions are selected under Drive|Tuning in the CS3000 main menu. If the
drive tuning functions are not supported for the selected drive, the menu item is
grayed.
When Drive|Tuning is selected from the CS3000 main menu, the menu appears as
follows:
Section 5.1 describes saving the drive configuration. Sections 5.2 and 5.3 describe
how to perform Standard tuning and Custom tuning for GV3000 and Liqui-Flo vector
drives.
Figure 5.1 – Drive Tuning Menu