Rockwell Automation CS3000 V6.1 MMI FlexPak, GV 3000, Liqui-Flo - Manual (Page 60)

6-8 Control and Configuration Software V6.1
6.7 Clearing the Monitor List Display
Use the Clear button on the Parameter Monitor to remove selected parameters or all
parameters from the monitor list display. This command only clears the parameters
shown in the monitor list; it does not remove them from the saved monitor list files.
To remove only parameters you select, follow these steps:
Step 1. Select Clear to display the Remove Parameters from Monitor List dialog box.
Step 2. Select the parameters you want to delete by using the mouse or the space
bar. Use the scroll bar, the arrow keys, and the page up and page down keys
to move through the list.
Step 3. Select Remove Selected to remove the parameters without exiting the dialog
box.
Step 4. If you want to remove more parameters, repeat this procedure. If you are
done removing parameters, select OK to return to the monitor list.
To remove all of the parameters, select Remove All. All of the parameters are removed
and you are returned to the monitor list.
6.8 Exiting the CS3000 Parameter Monitor
To exit the monitor list and return to the CS3000 main window, choose the Close
command from the CS3000 Parameter Monitor window. If a parameter list is displayed
in Parameter Monitor and it has not been saved to a file, you are prompted to save the
list. See section 6.5 for information about saving monitor list files.
Figure 6.5 – Remove Parameters from Monitor List Dialog Box