Rockwell Automation CS3000 V6.1 MMI FlexPak, GV 3000, Liqui-Flo - Manual (Page 71)

Controlling the Drive 8-5
Set the drive reference by:
• moving the scroll bar to change the reference value and automatically send the
value to the drive, or
• entering a new value in the edit box and selecting the Set button to send the
reference value to the drive
8.8 Setting the Jog Reference
The Jog reference box lets you set the jog reference. The valid values are the same as
for the manual reference. To do this:
Step 1. Click in the Jog reference box and type a new value.
Step 2. Press the Jog Set button.
8.9 Starting and Stopping the Drive
The following note applies to GV3000 and Liqui-Flo AC drives only.
Use the Run, Jog, and Stop/Reset buttons as follows:
!
ATTENTION: When parameter P.055 is set to ON, the STOP/RESET key
is functional only from the selected control source. As a safety precaution,
Reliance Electric recommends that an emergency stop push button be
located near the drive in an easily accessible location. As a further safety
precaution, the user should post a warning on the drive to alert personnel
that the STOP/RESET key is not functional. Failure to observe this
precaution could result in severe bodily injury or loss of life.
To send this command to the drive: Press: Description:
start Run This control is disabled if the CS3000
software is not the control source.
jog
(Releasing the button sends the stop command.)
You can also jog the drive using the keyboard instead of a
mouse. To jog the drive using the keyboard:
Step 1. To move to the Jog button, press [Tab].
Step 2. To send the jog command to the drive, press the
space bar.
Step 3. To send the stop command to the drive, release
the spacebar.
Jog (Note that buttons in Windows dialog
boxes normally cause an action when
the button is released). This control is
disabled if the CS3000 software is not
the control source.
stop
If the CS3000 software is the control source, a fault/alarm
reset is performed.
Stop/
Reset
— FlexPak 3000 - This control is always
enabled, regardless of the control
source.
— GV3000 or Liqui-Flo - This control
can be disabled using parameter
P.055. See the software reference
manual for more information.