Setting up a trace, 2 setting up a trace – Rockwell Automation CS3000 V6.1 MMI FlexPak, GV 3000, Liqui-Flo User Manual
Page 76
Advertising
9-4
Control and Configuration Software V6.1
To begin using PC Scope, follow these steps:
Step 1. Set up the trace by clicking
and defining the trace information. (See
section 9.2 for more information.)
Step 2. Choose how to acquire the trace data. (See section 9.3 for more information.)
9.2
Setting Up a Trace
Before you can acquire any trace data, you must set up the trace by:
•
specifying the signals for the trace(s) (See section 9.2.1.)
•
setting up data sampling (See section 9.2.2.)
•
setting up the trigger (See section 9.2.3.)
Set up a trace by using the Trace Signal Setup dialog box. To access this dialog box:
•
From the Trace menu, choose Setup or click
.
Figure 9.2 shows the Trace Signal Setup dialog box.
Figure 9.2 – Trace Signal Setup Dialog Box
Advertising