Rockwell Automation RSLogix 5000 Fuzzy Designer - Manual (Page 103)

Publication LOGIX-UM004A-EN-P - March 2007
FuzzyDesigner Projects 103
– Term Properties – Show the Term Properties dialog (see
section Term Properties Dialog) of the currently selected
term.
– Shift Selected Term Left – Shift the currently selected term to
the left.
– Shift Selected Term Right – Shift the currently selected term to
the right.
– Term DOFs Table Auto Arrange – Optimize the width of the
Term DOFs table columns.
– Zoom Out – Restore the membership function editor window
setting.
– Hide Term Names in Graph – Hide or show names of the
applied variable terms seen in the membership function
editor (except for Intermediate Linguistic Variable and Output
Takagi-Sugeno Variable).
– Variable Properties – Show the appropriate variable
properties dialog. The Term Editor dialog remains open.
IMPORTANT
To show the Term Properties dialog of an already selected
term, double-click anywhere in the membership function editor.
To change the parameters of the selected term membership
function only, right-click the term parameter and, in a
click-and-drag operation, move it to the new position. Repeat
as needed. This applies to the Input Linguistic Variable and
Output Linguistic Variable only.
IMPORTANT
To zoom in or out in the membership function editor, position
the mouse cursor anywhere in the editor area. Hold down the
right mouse button, and drag your mouse to the right (zoom in)
or left (zoom out). Release the button when the scale is at the
desired level.
When you want to zoom any part of membership function
editor, click the begin point by the right mouse button and move
the mouse right (the right mouse button is still pressed down) to
the final point. Release the right mouse button to rescale the
membership function editor. When the editor is zoomed, click
the right mouse button and move the mouse left or right to slide
the membership function editor zoom. To zoom out the editor,
click the right mouse button, drag the mouse left and release
the mouse button. Discussed mouse operation must be
performed inside the editor axes area.