Rockwell Automation AADvance Controller Demo Unit - Manual (Page 23)

Document: 553850 Issue 1.2: March 2011 2-1
This chapter will describe the process to set up the Demo Unit ready for configuring
the processor and I/O modules.
In This Chapter
Create a New Project ....................................................................................... 2-1
Changing the Properties of a Resource ........................................................ 2-2
Allocate IP Addresses for Network Communications.............................. 2-3
Configure the IP Address of the Target Controller .................................. 2-4
Downloading the Application to the Controller......................................... 3-1
Create a New Project
The configuration process starts by creating a new AADvance project. To create a
new project do the following:
1) Start the AADvance AADvance Workbench.
2) Select File then New Project/Library (<ctrl>+N).

The New dialog box opens.
3) Enter a project name (maximum of 128 characters) and add a comment line.
4) Choose the AADvance_System template from the drop down list, click OK.

The AADvance Workbench creates a project.
Chapter 2
Setting Up the Demo Unit