Rockwell Automation AADvance Controller Demo Unit - Manual (Page 4)

Demo Unit User Manual (AADvance Controller)
iv Document: 553850 Issue 1.2: March 2011
Contents
Chapter 1 Introduction - Demo Unit....................................................................... 1-1
Demo Unit........................................................................................................................................................... 1-1
Dimensions and Weight................................................................................................................................... 1-2
Dimensions.................................................................................................................................................... 1-2
Weight............................................................................................................................................................ 1-3
Display Panel and Power Connectors .......................................................................................................... 1-3
Overview ............................................................................................................................................................. 1-4
Hardware Configuration ............................................................................................................................ 1-4
T9110 Processor Module........................................................................................................................... 1-5
Processor Module Specification ............................................................................................................... 1-6
T9100 Processor Base Unit....................................................................................................................... 1-7
T9300 I/O Base Unit (3 way) .................................................................................................................... 1-8
T9401/2 Digital Input Module, 24V dc, 8/16 channel........................................................................ 1-10
T9401/2 Digital Input Module Specification......................................................................................... 1-11
T9451 Digital Output Module, 24V dc, 8 channel ............................................................................. 1-12
T9451 Digital Output Module Specification ........................................................................................ 1-13
T9431/2 Analogue Input Module, 8/16 Channel................................................................................. 1-14
T9431/2 Analogue Input Module Specification ................................................................................... 1-15
Chapter 2 Setting Up the Demo Unit ..................................................................... 2-1
Create a New Project ...................................................................................................................................... 2-1
Changing the Properties of a Resource........................................................................................................ 2-2
Allocate IP Addresses for Network Communications ............................................................................. 2-3
Configure the IP Address of the Target Controller.................................................................................. 2-4
Downloading the Application to the Controller........................................................................................ 3-1
Setting Up the Controller for AADvance Workbench Communications ..................................... 3-1
Chapter 3 Configuring the Controller Processor Modules ................................... 4-1
About The Configuration Process................................................................................................................. 4-1
About the 9110 Module Editor ...................................................................................................................... 4-2
Configure the Top-level Process Safety Time (PST)................................................................................. 4-3
Configure the Processor Battery Alarm ...................................................................................................... 4-4
Configure the Serial Ports ............................................................................................................................... 4-4
Serial Port Protocols................................................................................................................................... 4-5
Serial Port Parameters................................................................................................................................ 4-5
Configure the Controller as an SNTP Client ............................................................................................. 4-6
Configure the Controller as an SNTP Server............................................................................................. 4-7
Using the Controller as a Modbus Slave...................................................................................................... 4-8
Support for Modbus Slave Exceptions.................................................................................................... 4-9
Configure the Controller Modbus Slaves ............................................................................................ 4-10