Rockwell Automation AADvance Controller Demo Unit User Manual
Page 70
Demo Unit User Manual (AADvance Controller)
5-4
Document: 553850 Issue 1.2: March 2011
The slot and bus numbers must be the same as the actual physical position of the
installed modules. Therefore, for this example you would allocate I/O modules as
follows:
A 9401 module to the empty slot 1 on IO Bus 1
A 9451 module to the empty slot 2 on IO Bus 1.
Assign I/O Modules to I/O Bus Slots
If you are assigning a single module you can assign the module to any empty I/O bus
slot. If you are creating a redundant group you have to find two or three consecutive
empty slots and assign the module to the first empty slot in the group.
Note: If required, you can use the AADvance Workbench to move configured
modules to other slots to create a series of adjacent empty slots. Remember to move
the actual modules in the controller to the changed slots.
To assign an I/O module do the following:
1) Select the Equipment tab.
2) Expand the IO Bus 1.
3) At an empty slot right-click to select Insert IO. Move the cursor to the right to
select from the choice of available modules (empty slots position 16 - 24 shown in
bold).