Rockwell Automation FactoryTalk View Site Edition Installation Guide - Manual (Page 35)

3 • P RE - INSTALLATION CONFIGURATION
21
•
•
•
• •
To disable power saving for the NIC
The steps for disabling power saving for the NIC vary slightly for some of the Windows
operating systems. See the sections that apply to the operating systems you are using.
Follow the steps below.
1. Open Windows Control Panel, and then click Network and Internet.
2. From the list of categories, select Network and Sharing Center.
3. From the list of Tasks on the left, select Change adapter settings (or Manage
network connnections).
4. From the list of network connections, right-click Local Area Connection (or
Ethernet), and then select Properties.
5. In the Networking tab, click Configure.
6. In the Properties dialog box for the device, click the Power Management tab.
7. Clear the Allow the computer to turn off this device to save power check box,
and then click OK.
For Windows XP or Windows Server 2003
1. Open the Windows Control Panel, and then double-click Network Connections.
2. Right-click Local Area Connection, and then select Properties.
3. In the General tab, beside the network device name, click Configure.
4. In the Properties dialog box for the device, click the Power Management tab.
5. Clear the Allow the computer to turn off this device to save power check box,
and then click OK.
Disable or uninstall third-party firewalls
FactoryTalk View SE is compatible only with the built-in Windows firewall and should
not be used with third-party firewalls because this can cause unexpected results.
Before installing FactoryTalk View SE, disable or uninstall all third-party firewalls on the
computer. For details, see the documentation supplied with your firewall product.
Install Microsoft Internet Information Services
Microsoft IIS (Internet Information Services) is a critical service for a Distributed
FactoryTalk View SE System. Because of this, the Setup Wizard detects whether
Microsoft IIS is available on the computer and shows the status of that installation to the
user.
FTViewSEInstallENU.book Page 21 Wednesday, July 16, 2014 10:53 AM