Rockwell Automation FactoryTalk View Site Edition Installation Guide - Manual (Page 78)

F ACTORY T ALK V IEW S ITE E DITION I NSTALLATION G UIDE
64
• •
•
•
•
For example, if you restore System information, and if the Network Directory on the local
computer is active, you will replace user and computer accounts set up for any other
application using the active directory.
To back up a network distributed application
1. Click Start > All Programs > Rockwell Software > FactoryTalk View, and then
click FactoryTalk View Studio.
2. In the Application Type Selection dialog box, select Network Distributed, and then
click OK.
3. In the New/Open Site Edition (Network Distributed) Application dialog box, click
on the application you wish to back up.
RSLinx Enterprise device paths are also saved with System information, and might not be correct
for the computer where the application will be restored. For information about checking device
paths after restoring an application. see “Verify RSLinx Enterprise shortcuts” on page 118.
Before backing up an application, record the user names and passwords of administrative users
set up for the application, in case you need this information after restoring the application.
To back up a network distributed application, the logged on user must have FactoryTalk
administrative rights. If you receive a prompt to log on, check with your System Administrator.
FTViewSEInstallENU.book Page 64 Wednesday, July 16, 2014 10:53 AM