Rockwell Automation FactoryTalk View Site Edition Installation Guide - Manual (Page 36)

F ACTORY T ALK V IEW I NSTALLATION G UIDE
22
• •
•
•
•
IIS is required on the following computers:
Guidelines for different operating systems
Because of different versions and configurations for IIS, you may need to perform manual
steps for older operating systems before installing FactoryTalk View SE. Microsoft has
also changed its policy of including a key IIS component, WebDAV, in various operating
systems. This also will require manual steps to download and install WebDAV for older
operating systems.
 Need to manually install and configure IIS for these operating systems (see steps
below):
 Windows Server 2003
 Windows XP
 IIS is installed by FactoryTalk View Setup Wizard automatically in the other
supported operating systems.
 Need to manually download WebDAV from Microsoft and install:
 Windows Server 2008 with Service Pack 2
To install IIS on Windows Server 2003
1. Close all open Windows programs.
2. Place your Windows DVD in the computer’s DVD drive.
IIS required IIS not needed

FactoryTalk View SE Server

FactoryTalk View Studio that needs to
remotely connect to a Network
FactoryTalk View SE system.

FactoryTalk View SE Client

FactoryTalk View Studio

Stand Alone RSLinx Enterprise Server

Stand Alone FactoryTalk Directory
Server
If you have problems with the IIS setting, you can reference Appendix C, Install Microsoft
Internet Information Services.
You can only use Windows Vista to either host stand-alone or distributed applications that run on
a single computer, or run the FactoryTalk View SE Client or FactoryTalk View Studio software,
which can connect to an application hosted on the same computer, or an application hosted on a
remote computer. You cannot use Windows Vista to host HMI servers that other clients connect
to. To host HMI servers, use another supported operating systems instead.
FTViewSEInstallENU.book Page 22 Wednesday, July 16, 2014 10:53 AM