Rockwell Automation RECOMM-485 RS485 DFI Communications Module - Manual (Page 11)

Getting Started 2-1
C
HAPTER
2
Getting Started
This chapter provides:
• A description of the RS485 DF1 module’s components
• A list of parts shipped with the module
• A list of user-supplied parts required for installing the module
• An installation checklist
Œ
Status Indicators Four LEDs to indicate the status of the
connected drive, module, and network.
Refer to chapter 6 for more information
about the LEDs.

DPI Connector A 20-pin, single-row shrouded male
header. An Internal Interface cable
connects to this connector and one on
the drive.
Ž
RS485 DF1 Connector A 6-pin connector to which a 6-pin
linear plug can be connected.

Node Address Switches Switches to set the node address.

Data Rate Switch Switch to set the RS485 DF1 data rate
at which the module communicates.
Figure 2.1 – Components of the RS485 DF1 Module
Œ

Ž

