Rockwell Automation RECOMM-485 RS485 DFI Communications Module - Manual (Page 13)

Getting Started 2-3
2.2 Installation Checklist
This section is designed to help experienced users start using the
RS485 DF1 module. If you are unsure how to complete a step, refer
to the referenced chapter.
✔ Step Action Refer to:
❒ 1 Review the safety precautions for the
module. Throughout
this manual
❒ 2 Verify that the drive is properly installed. SP600 AC
Drive User
Manual
❒ 3 Commission the module.
Set a unique node address and the
appropriate data rate using the switches on
the module. If desired, you can disable the
switches and use parameter settings
instead.
Chapter 3
❒ 4 Install the module.
Verify that the drive is not powered. Then,
connect the module to the network using an
RS485 cable and to the drive using the
Internal Interface cable. Use the captive
screws to secure and ground the module to
the drive.
Chapter 3
❒ 5 Apply power to the module.
Apply power to the drive. (The module
receives power from the drive.) The status
indicators should be green. Refer to chapter
6 for more information if there is a problem.
Chapter 3
❒ 6 Configure the module for your
application.
Set the parameters for the following features
as required by your application:
• I/O configuration
• Fault actions
Chapter 4
❒ 7 Apply power to the RS485 DF1 master.
Verify that the master and the network are
installed and functioning in accordance with
RS485 DF1 standards.