Rockwell Automation RECOMM-485 RS485 DFI Communications Module - Manual (Page 29)

Configuring the RS485 DF1 Module 4-7
Set module parameter 9 (Reset Module) to “Reset Module.” See
figure 4.7.
When you enter 1 (“Reset Module”) the module is immediately
reset. When you enter 2 (“Set Defaults”) the module sets all
module parameters to their factory-default settings. The module
should be reset after performing a “Set Defaults.”
The value of this parameter is restored to 0 (“Ready”) after the
module is reset.
Figure 4.7 – Reset Screen on an LCD OIM
Port 5 Device
RECOMM-485
Parameter #: 9
Reset Module
1
Reset Module
Value Description
0 Ready (default)
1 Reset Module
2 Set Defaults