Rockwell Automation RECOMM-485 RS485 DFI Communications Module - Manual (Page 48)

B-2 RS485 DF1 Communications Module
Displays the port to which the module is connected. This will usually
be port 5.
Displays the data rate used by the drive. This rate is set in the drive
and the module detects it.
Sets the node address if the Data Rate Switch on the module is set
to “PGM” (Program).
Displays the DF1 node address actually used by the module.
1 DPI Port
Range: 0 to 7
Default: 5
Type: Read Only
Reset Required: N/A
2 DPI Data Rate
Range: 0 = 125 Kbps
1 = 500 Kbps
Default: 0 = 125 Kbps
Type: Read Only
Reset Required: N/A
3 DF1 Addr Cfg
Range: 0 to 254
Default: 1
Type: Read/Write
Reset Required: Yes
4 DF1 Addr Actual
Range: 0 to 254
Default: 1
Type: Read Only
Reset Required: N/A