Rockwell Automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 HP, 115/230 VAC - Manual (Page 18)

10 Installation
Mounting
Protect the drive from dirt, moisture, and accidental
contact. Provide sufficient room for access to the terminal
block and calibration trimpots.
Mount the drive away from other heat sources. Operate the
drive within the specified ambient operating temperature
range.
Prevent loose connections by avoiding excessive vibration
of the drive.
Mount the drive with its board in either a horizontal or
vertical plane. Four 0.19 inch (5 mm) wide slots in the
chassis accept #8 pan head screws.
ATTENTION: This drive contains ESD (Electric Static
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing,
servicing, or repairing this assembly. Failure to observe
these precautions could result in damage to, or
destruction of, the equipment.
ƽ
Chassis drive
250-0287-rev2.qxd 3/12/01 10:27 AM Page 10