Rockwell Automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 HP, 115/230 VAC - Manual (Page 44)

36
Operation
ATTENTION: Change voltage switch settings only
when the drive is disconnected from AC line voltage.
Make sure both switches are set to their correct
position. If the switches are improperly set to a lower
voltage position, the motor will not run at full voltage
and may cause damage to the transformer. If the
switches are improperly set to a higher voltage position,
the motor will overspeed, which may cause motor
damage, or result in bodily injury or loss of life.
ƽ
ATTENTION: Only qualified technical personnel,
familiar with the construction and operation of this
equipment and the hazards involved, should install,
adjust, operate and/or service this equipment. Read and
understand this instruction manual in its entirety before
proceeding. Failure to observe this precaution could
result in severe bodily injury or loss of life.
ATTENTION: All adjustments to these components
should be made with power removed. Failure to
observe this precaution could result in severe bodily
injury or loss of life.
ƽ
250-0287-rev2.qxd 3/12/01 10:27 AM Page 36