Rockwell Automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 HP, 115/230 VAC - Manual (Page 42)

34 Installation
ATTENTION: The DC3N does not have tachometer
loss or a field loss protection. Loss of field or
tachometer will cause the motor to run at maximum
uncontrolled speed. The user is responsible for assuring
safe conditions for operating personnel by providing
suitable guards, audio or visual alarms, or other devices.
Failure to observe these precautions could result in
bodily injury.
ƽ
Select the appropriate feedback option: ARMATURE for
armature feedback, or TACH for tachometer feedback.
SIGNAL (SW504)
Select the input signal being used: CURR for 4-20 mADC
current input signal, or VOLT for 0-10 VDC voltage input
signal or speed adjust potentiometer input.
FEEDBACK (SW505)
250-0287-rev2.qxd 3/12/01 10:27 AM Page 34