Rockwell Automation DC3E Non-Regenerative DC Drive User Guide 1/4 - 2 HP, 115/230 VAC - Manual (Page 35)

27 Installation
Connections
ATTENTION: A single fault like a power device short
may cause motor rotation when in the stop mode. The
user is responsible for assuring safe conditions for
operating personnel by providing suitable guards, audio
or visual alarms, or other devices. Failure to observe
these precautions could result in bodily injury.
ATTENTION: To provide the motor with overload
protection, local, national, and international codes
(e.g.,NEC/CEC) require that a motor thermostat,
internal to the motor, be installed or an electronic
thermal motor overload relay, sized to protect the
motor, be installed between the motor and the drives
output terminals.
ATTENTION: Do not connect this equipment with
power applied. Failure to observe this precaution may
result in fire or serious injury.
ƽ
250-0287-rev2.qxd 3/12/01 10:27 AM Page 27