Tweco 42 CutMaster Service Manual - Manual (Page 21)

INSTALLATION CUTMASTER 42
Manual 0-5171 3-1 Installation
SECTION 3:
INSTALLATION
3.01 Unpacking
1. Use the packing lists to identify and account for each item.
A. Contents List
Description Quantity
CM42 Power source 1
10ft power input cable (installed) 1
120VAC Adapter Pigtail 15A 1
120VAC Adapter Pigtail 20A 1
Work cable and clamp (installed) 1
SL40 Torch (15ft(4.6m)) w/consumables 1
Carry case 1
40A Tip Drag 2
20A Tip Drag 2
40A Tip, Standoff 2
Electrode 2
Gloves 1
Cutting Glasses 1
1/4" Pipe Size NPT female × BSPT male adapter 1
2. Inspect each item for possible shipping damage. If damage is evident, contact your distributor and / or shipping
company before proceeding with the installation.
3. Record Power Supply and Torch model and serial numbers, purchase date and vendor name, in the information
block at the front of this manual.
3.02 Lifting Options
The Power Supply includes a handle for hand lifting only. Be sure unit is lifted and transported safely and securely.
WARNING
Do not touch live electrical parts.
Disconnect input power cord before moving unit.
FALLING EQUIPMENT can cause serious personal injury and can damage equipment.
HANDLE is not for mechanical lifting.
• Only persons of adequate physical strength should lift the unit.
• Lift unit by the handle, using two hands. Do not use straps for lifting.
• Use optional cart or similar device of adequate capacity to move unit.
• Place unit on a proper skid and secure in place before transporting with a fork lift or other vehicle.