05 back panel removal, Cutmaster 42 disassembly procedure – Tweco 42 CutMaster Service Manual User Manual
Page 62
Advertising
CUTMASTER 42
DISASSEMBLY PROCEDURE
Disassembly Procedure 7-6 Manual 0-5171
7.05 Back Panel Removal
!
Read and follow safety information in Section 6.02 before proceeding with disassembly
1. Remove screws on back panel
2. Remove the three screws
3. Terminals from supply cable.
Disconnect two terminals from switch.
4. Wires from main PCB1 .
Disconnect the two terminals from switch.
5. Goung wire terminal.
Remove the nut.
1
2
3
4
5
Art # A-10253
Advertising