Tweco 200 Ultra-Cut - Manual (Page 3)

!
WARNINGS
Read and understand this entire Manual and your employer’s safety practices before
installing, operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judge-
ment, the Manufacturer assumes no liability for its use.
Plasma Cutting Power Supply, Ultra-Cut ® 200
Operting Manual No. 0-5056
Published by:
Thermadyne Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
www.thermal-dynamics.com
© Copyright 2007, 2008, 2009, 2010, 2011, 2012 by
Thermadyne Corporation
All rights reserved.
Reproduction of this work, in whole or in part, without written per-
mission of the publisher is prohibited.
The publisher does not assume and hereby disclaims any liability to
any party for any loss or damage caused by any error or omission
in this Manual, whether such error results from negligence, acci-
dent, or any other cause.
Licensed under U. S. Patent No. 5,070,227
Original Publication Date: December 19, 2007
Revision Date: August 31, 2012
Record the following information for Warranty purposes:
Where Purchased: ___________________________________
Purchase Date:______________________________________
Power Supply Serial #:_______________________________
Torch Serial #:_____________________________________