Tweco 200 Ultra-Cut - Manual (Page 72)

Manual No. 0-5056 Ultra-Cut 200 4-6 OPERATION
Adjusts the output current of the power supply.
High Precision
Plasma Cutting System
PREFLOW
H 2 O
MIST
PLASMA SHIELD
PRESSURE
PLASMA
POWER SUPPLY
GAS
FLOW
High Precision
Plasma Cutting System
ENABLE
DISABLE
GAS MODE
RUN
SET PREFLOW
SET PLASMA & SHIELD
TEST
O2 - AIR
O2 - O2
H35 -N 2
F5 - N 2
AIR - AIR
N 2 - H 2 O
N 2 - N 2
9 9
Art # A-04767
GCM
2010
The DISABLE position removes input power from the Power Supply inverters, disables the coolant pump and
fan, the pilot contactor & HF and removes AC power from the gsa control solenoids shutting off all gas flow.
When the switch is returned to the ENABLE position an automatic gas purge is started and then the system is
returned to normal operation under control of the CNC device.
Used to set preflow gas pressure and flow. MODE switch must be in SET PREFLOW position.
Used to set plasma and shield gas pressures and flows. Mode switch must be in SET PLASMA & SHIELD
position.
At lower flow rates shield gas pressure is first set per the cut charts then the flow is set using the flow meter
with the GAS switch set in the FLOW position. Some torch parts require higher flow rates that execeed the
capacity of the flow meter. In that case, Gas switch is set in the PRESSURE position and the regulator and
gauge is used to set pressure per the cut charts when no “Ball” setting is shown.
Used to set water flow rate. MODE switch must be in SET PLASMA & SHIELD position. GAS selection switch
must be in N
2
-H
2
O position.
Water mist is not used in all applications.