Chassis intrusion switch, Removing the chassis intrusion switch, See "chassis – Dell PowerVault NX200 User Manual

Page 120: Intrusion switch" on

Advertising
background image

118

Installing System Components

13 Close the system. See "Closing the System" on page 80.
14 Place the system upright on a flat surface.
15 Reattach any peripherals and connect the system to an electrical outlet.
16 Turn on the system and attached peripherals.
17 Enter the System Setup program to confirm that the battery is operating

properly. See "Entering the System Setup Program" on page 52.

18 Enter the correct time and date in the System Setup program's Time and

Date fields.

19 Exit the System Setup program.

Chassis Intrusion Switch

Removing the Chassis Intrusion Switch

CAUTION:

Many repairs may only be done by a certified service technician.

You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.

1 Turn off the system and attached peripherals, and disconnect the system

from the electrical outlet and peripherals.

2 Open the system. See "Opening the System" on page 79.
3 Disconnect the chassis intrusion switch cable from the connector on

the system board. See Figure 3-21.

4 Slide the chassis intrusion switch out of the securing bracket notch.

book.book Page 118 Monday, August 9, 2010 3:07 PM

Advertising