Dell PowerVault NX200 - Manual (Page 85)

Installing System Components 83
Figure 3-6. Removing and Installing the Cooling Shroud
Installing the Cooling Shroud
1 Carefully lower the cooling shroud into the system holding by the
touch point.
2 Ensure that no cables are pinned under the edges of the cooling shroud.
3 Secure the cable into the bracket on the side of the cooling shroud.
4 Replace the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer" on page 81.
5 Close the system. See "Closing the System" on page 80.
1 cooling shroud 2 expansion card stabilizer
3 expansion card stabilizer touch
points (2)
4 cable bracket
5 cooling shroud touch point
1
2
3
5
4
book.book Page 83 Monday, August 9, 2010 3:07 PM