Dell PowerVault NX200 - Manual (Page 153)

Jumpers and Connectors 151
6
Jumpers and Connectors
WARNING: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
System Board Jumpers
For information on resetting the password jumper to disable a password,
see "Disabling a Forgotten Password" on page 156.
Table 6-1. System Board Jumper Settings
Jumper Setting Description
PWRD_EN (default) The password feature is enabled (pins 2-4)
The password feature is disabled, and iDRAC6
local access is unlocked at the next AC power
cycle (pins 4-6)
NVRAM_CLR (default) The configuration settings are retained at system
boot (pins 3-5)
The configuration settings are cleared at the next
system boot (pins 1-3)
book.book Page 151 Monday, August 9, 2010 3:07 PM