Dell PowerVault NX200 - Manual (Page 121)

Installing System Components 119
Figure 3-21. Removing and Installing the Chassis Intrusion Switch
Installing the Chassis Intrusion Switch
1 Align the chassis intrusion switch with the securing bracket notch.
See Figure 3-21.
2 Slide the switch into the securing bracket notch. See Figure 3-21.
3 Connect the chassis intrusion switch cable to the connector on
the system board.
4 Close the system. See "Closing the System" on page 80.
5 Place the system upright on a flat surface.
6 Reattach any peripherals and connect the system to an electrical outlet.
7 Turn on the system and attached peripherals.
1 chassis intrusion switch 2 chassis intrusion switch cable
3 intrusion connector on the
system board
1
2
3
book.book Page 119 Monday, August 9, 2010 3:07 PM