Dell PowerVault NX200 - Manual (Page 48)

48 About Your System
Unable to launch
System Services
image. System
halted! System halted after
F10 keystroke because
System Services image
is either corrupted in the
system firmware or has
been lost due to system
board replacement.
Restart the system and
update the Unified Server
Configurator repository to
the latest software to restore
full functionality. See the
Unified Server Configurator
user documentation for more
information.
Unexpected
interrupt in
protected mode Improperly seated
memory modules or
faulty keyboard/mouse
controller chip.
Reseat the memory modules.
See "Troubleshooting System
Memory" on page 137. If the
problem persists, see
"Getting Help" on page 157.
Unsupported CPU
combination
Unsupported CPU
stepping
detected Processor is not supported
by the system.
Install a supported processor.
See "Processor" on page 112.
Unsupported
DIMM detected.
The following
DIMM has been
disabled: x Invalid memory
configuration. The system
will run but with the
specified memory
module disabled.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 98.
Unsupported
memory
configuration.
DIMM mismatch
across slots
detected:
x,x,... Invalid memory
configuration. Memory
modules are mismatched
in the specified slots.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 98.
Table 1-2. System Messages (continued)
Message Causes Corrective Actions
book.book Page 48 Monday, August 9, 2010 3:07 PM