Dell PowerVault NX200 - Manual (Page 40)

40 About Your System
General failure The operating system is
unable to carry out the
command.
This message is usually
followed by specific
information. Note the
information, and take the
appropriate action to resolve
the problem.
Invalid
configuration
information -
please run SETUP
program. An invalid system
configuration caused a
system halt.
Run the System Setup
program and review the
current settings. See "Using
the System Setup Program
and UEFI Boot Manager" on
page 51.
Keyboard
controller
failure Faulty keyboard controller;
faulty system board
See "Getting Help" on
page 157.
Keyboard data
line failure
Keyboard stuck
key failure Keyboard cable connector is
improperly connected or the
keyboard is defective.
Reseat the keyboard cable.
If the problem persists,
see "Troubleshooting a USB
Device" on page 130.
Keyboard fuse has
failed Overcurrent detected at the
keyboard connector.
See "Getting Help" on
page 157.
Local keyboard
may not work
because all user
accessible USB
ports are
disabled. If
operating
locally, power
cycle the system
and enter system
setup program to
change settings. The USB ports are disabled
in the system BIOS.
Power down and restart the
system from the power
button, and then enter the
System Setup program to
enable the USB port(s).
See "Entering the System
Setup Program" on page 52.
Manufacturing
mode detected System is in
manufacturing mode.
Reboot to take the system
out of manufacturing mode.
Table 1-2. System Messages (continued)
Message Causes Corrective Actions
book.book Page 40 Monday, August 9, 2010 3:07 PM