Dell POWERVAULT MD3620I - Manual (Page 139)

Configuration: Disk Groups and Virtual Disks 139
associated source virtual disk. Changing the RAID controller module
ownership of a virtual disk changes the preferred RAID controller module
ownership of the virtual disk.
During a virtual disk copy, the same RAID controller module must own both
the source virtual disk and the target virtual disk. Sometimes both virtual
disks do not have the same preferred RAID controller module when the
virtual disk copy starts. Therefore, the ownership of the target virtual disk is
automatically transferred to the preferred RAID controller module of the
source virtual disk. When the virtual disk copy is completed or is stopped,
ownership of the target virtual disk is restored to its preferred RAID controller
module. If ownership of the source virtual disk is changed during the virtual
disk copy, ownership of the target virtual disk is also changed. Under certain
operating system environments, it may be necessary to reconfigure the multi-
path driver before an I/O path can be used.
To change the ownership of the virtual disk to the connected controller:
1 In the AMW, select the Logical tab and select a virtual disk.
2 Select Virtual Disk Change Ownership/Preferred Path.
3 Select the appropriate RAID controller module slot and click Yes to
confirm the selection.
Removing Host-to-Virtual Disk Mapping
To remove the host to virtual disk mapping:
1 In the AMW, select the Mapping tab.
2 Select a virtual disk from the Defined Mappings pane.
3 Perform one of these actions:
• Select Mappings Remove.
• Right-click the virtual disk, and select Remove Mapping from the
pop-up menu.
4 Click Yes to remove the mapping.
Changing the RAID Controller Module Ownership of a Disk Group
You can change the RAID controller module ownership of a disk group.
book.book Page 139 Tuesday, June 18, 2013 3:09 PM