Control panel, Removing the control panel – Dell POWERVAULT MD3620I User Manual
Page 239
Management: Installing Array Components
237
Control Panel
Removing the Control Panel
1 Turn off the array and host server.
2 Disconnect all the power cables connected to the array.
3 Remove the hard drives from:
–
slots 0 to 2 in PowerVault MD3600i
–
slots 0 to 5 in PowerVault MD3620i
See "Removing a Hard Drive" on page 222.
NOTE:
Mark each hard drive with it’s slot position as you remove it.
4 Slide the control panel out of the chassis after:
–
Pushing the release tab toward the front of the array in PowerVault
MD3600i. See Figure 16-13.
–
Pulling the release pin toward the front of the array in PowerVault
MD3620i. See Figure 16-14.
Figure 16-13. Removing and Installing the Control Panel-PowerVault MD3600i
1
control panel
2
release tab
2
1
book.book Page 237 Tuesday, June 18, 2013 3:09 PM