Dell POWERVAULT MD3620I User Manual

Page 26

Advertising
background image

26

Planning: About Your Storage Array

3

Split mode LED

This LED must be unlit as the split mode

function is not supported by the MD3600i Series

storage arrays.

4

System identification

button

The system identification button on the front

control panel can be used to locate a particular

enclosure within a rack. When the button is

pushed, the system status indicators on the

control panel and the RAID controller module(s)

blink blue until the button is pushed again.

5

Hard drives

MD3600i—Up to twelve 3.5" SAS hot-swappable

hard drives.
MD3620i—Up to twenty four 2.5" SAS hot-

swappable hard drives.

6

Enclosure mode

switch

The function of this switch is not applicable to

your storage array. However, if MD1200 Series

expansion enclosures are daisy chained to the

storage array, the enclosure mode switches of the

MD1200 Series expansion enclosures must be set

to the Unified-Mode position.

NOTE:

This switch must be set before turning on

the MD1200 series

expansion enclosure. Changing

the switch setting after the expansion enclosure is

turned on has no effect on the enclosure

configuration until the expansion enclosure goes

through a complete power cycle.

Item Indicator, Button, or

Connector

Icon Description

book.book Page 26 Tuesday, June 18, 2013 3:09 PM

Advertising
This manual is related to the following products: