Dell POWERVAULT MD3620I - Manual (Page 79)

Configuration: About Your Storage Array 79
Configuring Alert Notifications
MDSM can send an alert for any condition on the storage array that requires
your attention. Alerts can be sent as e-mail messages or as Simple Network
Management Protocol (SNMP) trap messages.
You can configure alert notifications either for all the storage arrays or a single
storage array.
To configure alert notifications for all storage arrays:
1 In the EMW, select the Setup tab.
2 Select Configure Alerts.
The Configure Alerts dialog is displayed.
3 Select All storage arrays.
4 Click OK.
The Configure Alerts dialog is displayed. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 79. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 82.
To configure alert notifications for a single storage array:
1 In the EMW, select the Devices tab.
2 Select the relevant storage array, then select EditConfigure Alerts.
The Configure Alerts dialog is displayed. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 79. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 82.
Configuring E-mail Alerts
For more information on configuring alert notifications, see "Configuring
Alert Notifications" on page 79.
To configure e-mail alerts:
1 Open the Configure Alerts dialog by performing one of these actions:
• In the tree view or the table view on the Devices tab in the EMW,
select a node, and then select Edit Configure Alerts. Go to step 3.
• In the Setup tab in the EMW, select Configure Alerts. Go to step 2.
2 Select one of the following radio buttons to specify an alert level:
book.book Page 79 Tuesday, June 18, 2013 3:09 PM