Dell POWERVAULT MD3620I - Manual (Page 225)

Management: Installing Array Components 223
2 From the Modular Disk Storage Manager (MDSM) software, prepare the
drive for removal. Wait until the hard-drive indicators on the drive
carrier signal that the drive can be removed safely. For more information,
see your controller documentation for information about hot-swap drive
removal.
If the drive is online, the green activity/fault indicator flashes as the drive
is powered down. When the drive indicators are off, the drive is ready for
removal.
3 Press the release button to open the drive carrier release handle. See
Figure 16-4.
4 Slide the hard drive out until it is free of the drive bay.
CAUTION: To maintain proper system cooling, all empty hard-drive bays must
have drive blanks installed.
5 Insert a drive blank in the empty drive bay. See "Installing a Hard-Drive
Blank" on page 222.
6 If applicable, replace the front bezel. See "Installing the Front Bezel" on
page 220.
Figure 16-4. Removing and Installing a Hard Drive
1 release button 2 hard-drive carrier handle
1
2
book.book Page 223 Tuesday, June 18, 2013 3:09 PM