Dell POWEREDGE M1000E User Manual
Page 123
Privilege
Description
Based on the privileges responding from the server, CMC firmware decides if
the user has the right to perform the action.
Listed below are the privileges and the actions on the server to which the
Server Administrator is entitled. These rights are applied only when the
chassis user does not have the Server Administrative privilege on the
chassis.
Server Configuration Administrator:
•
Set IP address
•
Set gateway
•
Set subnet mask
•
Set first boot device
Configure Users:
•
Set iDRAC root password
•
iDRAC reset
Server Control Administrator:
•
Power on
•
Power off
•
Power cycle
•
Graceful shutdown
•
Server Reboot
Test Alert User
User can send test alert messages.
Debug Command Administrator
User can execute system diagnostic commands.
Fabric A Administrator
User can set and configure the Fabric A IOM, which resides in either slot A1
or slot A2 of the I/O slots.
Fabric B Administrator
User can set and configure the Fabric B IOM, which resides in either slot B1
or slot B2 of the I/O slots.
Fabric C Administrator
User can set and configure the Fabric C IOM, which resides in either slot C1
or slot C2 of the I/O slots.
The CMC user groups provide a series of user groups that have pre-assigned user privileges.
NOTE: If you select Administrator, Power User, or Guest User, and then add or remove a privilege from the pre-
defined set, the CMC Group automatically changes to Custom.
Table 19. : CMC Group Privileges
User Group
Privileges Granted
Administrator
•
CMC Login User
•
Chassis Configuration Administrator
•
User Configuration Administrator
•
Clear Logs Administrator
•
Server Administrator
•
Test Alert User
123