Dell POWEREDGE M1000E - Manual (Page 230)

The administrator account is temporarily reset regardless if the administrator account was removed, or if the password
was changed.
NOTE: When the PASSWORD_RST jumper is installed, a default serial console configuration is used (rather than
configuration property values), as follows:
cfgSerialBaudRate=115200
cfgSerialConsoleEnable=1
cfgSerialConsoleQuitKey=^\
cfgSerialConsoleIdleTimeout=0
cfgSerialConsoleNoAuth=0
cfgSerialConsoleCommand=""
cfgSerialConsoleColumns=0
1. Press the CMC release latch on the handle and move the handle away from the module front panel. Slide the CMC
module out of the enclosure.
NOTE: Electrostatic discharge (ESD) events can damage CMC. Under certain conditions, ESD may build up on
your body or an object, and then discharge into your CMC. To prevent ESD damage, you must take
precautions to discharge static electricity from your body while handling and accessing CMC outside the
Chassis.
2. Remove the jumper plug from the password reset connector, and insert a 2-pin jumper to enable the default
administrator account. To locate the password jumper on the CMC board, see the following figure.
Figure 9. Password Reset Jumper Location
Table 43. CMC Password Jumper Settings
PASSWORD_RSE
T (default) The password reset feature is disabled.
The password reset feature is enabled.
3. Slide the CMC module into the enclosure. Reattach any cables that were disconnected.
230