Dell POWEREDGE M1000E - Manual (Page 168)

The General Chassis Settings page is displayed.
The FlexAddress has a value Active or Not Active. The value Active indicates that the feature is installed on the chassis
and Not Active indicates that the feature is not installed and not in use on the chassis.
Use the following RACADM command to display FlexAddress status for the entire chassis:
racadm getflexaddr
To display FlexAddress status for a particular slot:
racadm getflexaddr [-i <slot#>]
where <slot#> is a value from 1– 16.
For additional information on getflexaddr command, see the RACADM Command Line Reference Guide for iDRAC7 and
CMC. at dell.com/support/manuals.
Viewing FlexAddress Information For All Servers
To view FlexAddress status for all the servers using CMC Web interface, in the system tree, go to Server Overview →
Properties → WWN/MAC .
The WWN/MAC Summary page is displayed providing the following information for all the slots in the chassis.
Fabric
Configuration Fabric A, Fabric B, and Fabric C display the type of the Input/Output fabric installed.
iDRAC displays the server management MAC address.
NOTE: If Fabric A is enabled, unpopulated slots display chassis-assigned MAC addresses for
Fabric A and MAC or WWNs for Fabrics B and C if they are in use by populated slots.
WWN/MAC
Addresses Displays FlexAddress configuration for each slot in the chassis. Information displayed includes:
• Slot number and location.
• FlexAddress is active or not active.
• Fabric type.
• Server-assigned and chassis-assigned WWN/MAC addresses in use.
A green check mark indicates the active address type, either server-assigned or chassis-
assigned.
NOTE: iDRAC management controller is not a fabric but its FlexAddress is treated like one.
NOTE: FlexAddress is not supported for EqualLogic PS-M4110 Blade Array.
For information about the fields, see the CMC Online Help.
Viewing FlexAddress Information for Individual Servers
To view FlexAddress information for a particular server using the CMC Web interface:
1. In the system tree, expand Server Overview.
All the servers (1–16) appear in the expanded Servers list.
2. Click the server you want to view. .
The Server Status page is displayed
3. Click the Setup tab, and then the FlexAddress subtab.
The FlexAddress page is displayed that provides the WWN configuration and MAC addresses for the selected
server. For more information, see the
CMC Online Help.
168