Installing and removing hot-plug scsi hard drives, Figure 7-11 and, Figure 7-11 – Dell PowerEdge 1800 User Manual
Page 111
Advertising
Installing Drives
111
Installing and Removing Hot-Plug SCSI Hard Drives
NOTE:
SCSI hot-plug functionality is available only when SCSI RAID is used. See the SCSI RAID
controller's documentation to verify that its configuration supports hot-plug SCSI hard drives.
The drive bays in a system with an optional SCSI backplane board provide space for up to six
1-inch hard drives. The hard drives plug into the SCSI backplane board, which is connected to a
controller on the system board or to a RAID controller card. See Figure 7-11 and Figure 7-12.
Figure 7-11.
Hot-Plug SCSI Hard Drives Connected to the Integrated SCSI Controller
SCSI connector
38-cm (15-inch) SCSI interface cable
SCSI backplane board
SCSI hard drives (6)
Advertising