Dell POWEREDGE C6105 - Manual (Page 102)

102 | Installing System Components
10 Place the expansion-card assembly into the system-board assembly.
11 Replace the four screws that secure the expansion-card assembly.
12 Replace the system-board assembly. See "Installing a System-Board
Assembly" on page 93.
LSI 9260-8i Card
NOTE: The LSI 9260-8i card assembly should include the BBU interposer card
which is connected to the RAID battery. The illustrations in this section are just
for your removal and installation reference. For more information of the RAID
battery, see “LSI 9260-8i RAID Battery (Optional)” on page 107.
Removing the LSI 9260-8i Card
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1 Remove the system-board assembly. See "Removing a System-Board
Assembly" on page 92.
2 Disconnect the two SAS/SGPIO cables connecting to the LSI 9260-8i
card assembly.
3 Remove the four screws that secure the LSI 9260-8i card assembly. See
Figure 3-11.
4 Lift the LSI 9260-8i card assembly out of the system-board assembly.
See Figure 3-11.