Dell POWEREDGE C6105 - Manual (Page 187)

Troubleshooting Your System | 187
Remove and reinstall the drivers if applicable. See the NIC's
documentation.
 Change the auto-negotiation setting, if possible.
 Use another connector on the switch or hub.
If you are using a NIC card instead of an integrated NIC, see the
documentation for the NIC card.
3 Ensure that the appropriate drivers are installed and the protocols are
bound. See the documentation for the NIC card.
4 Enter the System Setup program and confirm that the NIC ports are
enabled. See "Using the System Setup Program" on page 37.
5 Ensure that the NICs, hubs, and switches on the network are all set to
the same data transmission speed. See the documentation for each
network device.
6 Ensure that all network cables are of the proper type and do not exceed
the maximum length.
If all troubleshooting fails, see "Getting Help" on page 215.
Troubleshooting a Wet System
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1 Turn off the system and attached peripherals, and disconnect the
system from the electrical outlet.
2 Open the system. See "Opening the System" on page 142.
3 Disassemble components from the system. See "Installing System
Components" on page 82.
 Hard drives
 SAS backplane