Dell POWEREDGE C6105 - Manual (Page 111)

Installing System Components | 111
Installing the LSI 9260-8i RAID Battery Carrier
1 Place the LSI 9260-8i RAID battery carrier in position on the interposer
extender. See Figure 3-15.
2 Replace the screws securing the LSI 9260-8i RAID battery carrier to the
interposer extender. See Figure 3-15.
3 Install the LSI 9260-8i RAID battery into the LSI 9260-8i RAID battery
carrier. See ―Installing the LSI 9260-8i RAID Battery‖ on page 108.
4 Replace the system-board assembly. See ―Installing a System-Board
Assembly‖ on page 93.
LSI 9265-8i Card
NOTE: The LSI 9265-8i card assembly should include the BBU interposer card
which is connected to the RAID battery. The illustrations in this section are just
for your removal and installation reference. For more information of the RAID
battery, see “LSI 9265-8i RAID Battery (Optional)” on page 115.
Removing the LSI 9265-8i Card
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1 Remove the system-board assembly. See "Removing a System-Board
Assembly" on page 92.
2 Disconnect the two SAS/SGPIO cables connecting to the LSI 9265-8i
card assembly.
3 Remove the four screws that secure the LSI 9265-8i card assembly. See
Figure 3-16.