Wine Guardian Ducted Split Wine Cellar Cooling Systems (WGS175) - Manual - Manual (Page 72)

73
Room sensor
calibration 室内传感器
校准
Setting 15 设置 15
 Press “Settings” button to advance to Setting 15.
按
“模式”按钮，直至设定 15。
 Press the “Up” or “Down” buttons to adjust to the
desired set point. Maximum setting is +2°C,
minimum setting is -2°C. Factory default is zero
(0). Sensor calibration set point changes the actual
display reading (temperature only) by the value of
this setting.
按 “向上”或“下移”按钮来调整所需的设定点。
最大设置为+2° C，最小设置为-2 C。出厂默认
值是零（0）。传感器校准设置点设置值的更
改，会影响实际显示的读数（只有温度）。
Example: Sensor reading = 13 Deg C 范例：传
感器读数=13 摄氏度。
Setting 15 set to +2 设置 15 设置为+2
Display reading = 15 Deg C 显示读数=15 摄氏
度
Differential
temperature
adjustment 温度差分调
节 Setting 16 设置 16
 Press “Settings” button to advance to Setting 16.
按“模式”按钮，直至设定 16。
 Press the “Up” or “Down” buttons to adjust to the
desired set point.
按 “向上”或“向下”按钮调整到所需的设定点。
This setting changes the system/compressor turn-on
temperature above set point. Factory default is set to
1°C.
此设置更改提高了系统/压缩机开启温度
设定点以上。出厂默认设置为 1 ° C。
Example: Sensor reading = 13°C
范例：
Setting 16 set to +1°C
设置 16 设置为+1°
C 摄氏 传感器读数=13° C
System/compressor turns on at 14 Deg. C. 系统/压缩
机摄氏 14 度开启。
Deadband setting 死区
设置 （启动间距） Setting 17 设置 17
 Press “Settings” button to advance to Setting 17.
按“模式”按钮，直至设定 17。

Press the “Up” or “Down” buttons to adjust to the
desired set point.
按
“向上”或“向下”按钮调整到所需的设定点
This setting is the minimal allowable temperature
difference between heating and cooling set points.
Maximum is 3°C, minimum is 1°C. Factory default is
set to 1°C
此设置是最小的制热和制冷设定点之间的允许温
差。最大为 3° C 摄氏，最低为 1 ° C 摄氏。出厂
默认设置为 1° C 摄氏度。
Test mode setting 测试 Setting 18
 Press “Settings” button to advance to Setting 7.
SERVICE MANUAL ONLY
维护手册
专用