KEYENCE FS-N10 Series - Manual (Page 83)

4-6 2-output Settings ( )
4
Set
tings
f
o
r
Ad
v
an
ced F
u
nct
ion
s
4-37 - Digital Fiber Sensor FS-N10 Series User's Manual -
Warning output mode
If output 2 is set to " ALrt " (warning output mode), output 2 turns on (or off if the output
condition is set to N.C.) when either of the following errors occur:
• Correction error in DATUM1 or DATUM 2 mode
• END-APC error
For error recovery procedures, see "Troubleshooting" (page 6-2).
Refer to page 4-3 "2-output Settings ( )" for setting methods.
Reference