AERCO RECON 1000 - Manual (Page 44)

RECON Water Heaters Installation, Operation & Maintenance Manual
CHAPTER 3 – OPERATION
Page 44 of 178 AERCO International, Inc.  100 Oritani Dr.  Blauvelt, NY 10913 OMM-0103_0A
PRI: 10/28/2014 Phone: 800-526-0288 GF-147
3.4 OPERATING MENU
The Operating Menu displays a number of key operating parameters for the unit, as listed in
Table 3-2. This menu is “Read-Only” and does not allow personnel to change or adjust any
displayed items. It can therefore be viewed at any time without entering a password. Pressing
the ▲ arrow key to display the menu items in the order listed (Top-Down). Pressing the ▼
arrow key will display the menu items in reverse order (Bottom-Up).
A full description of each item appears in Table A-1 of Appendix A – Recon Menu Item
Descriptions.
Table 3-2: Operating Menu
Menu Item Display
Available Choices or Limits Appears only if enabled
in the following menu:
Minimum Maximum
1 Active Setpoint 40°F 190°F
2 Inlet Temp 30°F 240°F Calibration Menu
3 Air Temp -70°F 245°F
4 * Outdoor Temp -70°F 130°F Configuration Menu
5 Valve Position In 0% 100%
6 Exhaust Temp 40°F 560°F
7 Valve Position Out 0% 100% Calibration Menu
8 FFWD Temp 30°F 240°F Calibration Menu
9 Flame Strength 0% 100%
10 Oxygen Level -32% 32%
11 Ignition Time 0.00 10.00
12 SSOV Time to OPN 0.00 10.00
13 Run Cycles 0 999,999,999
14 Run Hours 0 999,999,999
15 Fault Log 0 19
* NOTE
The Outdoor Temp display item will not be displayed unless the
Outdoor Sensor function has been enabled in the Configuration
Menu (Table 3-4).