AERCO RECON 1000 - Manual (Page 7)

RECON Water Heaters Installation, Operation & Maintenance Manual
FORWARD
OMM-0103_0A AERCO International, Inc.  100 Oritani Dr.  Blauvelt, NY 10913 Page 7 of 178
GF-147 Phone: 800-526-0288 PRI: 10/28/2014
FOREWORD
The AERCO RECON Series Potable Water Heaters are modulating units which represent a true
industry advance that meets the needs of today's energy efficiency and environmental
concerns. Designed for use in any domestic water heating system, each RECON model
provides precisely-controlled potable water within ±2°F of setpoint, for up to 50% load changes.
RECON’s compact size and varied venting capabilities allow maximum installation flexibility.
The RECON Series Heaters, with their load tracking controls modulate over a 10:1
turn down
ratio to match the system demand and yield high thermal efficiencies.
RECON Water Heaters are available in two different sizes: 500,000 BTU/Hr. input and
1,000,000 BTU/Hr. input. In addition, all RECON Heater sizes now include Water Heater
Management (WHM) software which is built into the C-More Controller furnished with each unit.
When the heater is ordered with a Sequencing Valve (SV), up to eight (8) water heaters can be
controlled by the WHM system utilizing RS485 Modbus protocol. All available Water Heater
models are listed in the table on the following page. As this table shows, units can be ordered
with Factory Mutual (FM) or Double Block and Bleed (formerly IRI) Gas Trains. If Sequencing
Valves are required please specify that with your order and they will be added as a line item.
When installed in accordance with this Instruction Manual, the RECON Series Models covered
herein comply with the NOx emission standards outlined in:
 South Coast Air Quality Management District (SCAQMD), Rule 1146.2
 Texas Commission on Environmental Quality (TCEQ), Title 30, Chapter 117,
Rule 117.465
Whether used in singular or modular arrangements, the RECON Heaters offer the maximum
flexibility in venting with minimum installation space requirements – see our available Venting
Guide for specifics on installation and/or contact AERCO International, Inc. RECON’s advanced
electronic controls offer simplified integration with today’s Energy Management Systems.
For service or parts, contact your local sales representative or AERCO International, Inc.
NOTE
Unless otherwise specified, the descriptions and procedures provided in
this Installation, Operation & Maintenance Manual apply to all RECON
Series Water Heaters.